If an extinguisher weighs less than 40 lbs, the carrying handle should be no more than 5 ft from the ground. Any heavier than 40 lbs and the handle should be no more than 3.5 ft from the floor. These heights reflect the requirement that employees should be able to access a fire extinguisher without risking an injury.
(1) Extinguishing agents must be nonflammable, non-poisonous, and non-corrosive as defined in this subchapter; and (2) Packages must be marked as specified for limited quantities in § 172.315 of this subchapter. (e) Large fire extinguishers may be transported while unpackaged under the following conditions: (1) The requirements of § 173.24(b) are met;
DOT Requirements for Fire Extinguishers – Industrial …
The Fire Extinguisher must have an Underwriter’s Laboratories (UL) rating of 10 B:C or more. If the power unit is not used to transport hazardous materials it …
Class a Fire Extinguisher Mounting Requirements. Class A fire extinguishers have an additional floor area requirement. The maximum floor area that a single class A fire extinguisher can cover is directly tied to the extinguisher’s numerical rating and floor hazard occupancy. The maximum floor area for this type is set ft 2.
People Also Ask a fire extinguisher must conform to which requirement
How many 2 a fire extinguishers are required in a building?
NFPA recommends one 2-A fire extinguisher for every 3,000 square feet. OSHA requires employees to have access to an extinguisher within 75 feet. Employees should have access to a fire extinguisher within either 30 or 50 feet, depending on the hazard in question and the rating of the extinguisher (see below).
What do the words “this extinguisher meets all requirements” mean?
The words “This extinguisher meets all requirements of 49 CFR 173.306 ” may be displayed on fire extinguishers manufactured prior to January 1, 1976; (5) Each non-specification fire extinguisher must be packaged as an inner packaging within a combination outer packaging.
What are the requirements for a non specification fire extinguisher?
(c) Non-specification cylinders are authorized as fire extinguishers subject to the following conditions: (1) Extinguishing agents must be nonflammable, non-poisonous, and non-corrosive as defined in this subchapter; (2) The internal volume of each cylinder may not exceed 18 L (1,100 cubic inches).
Do fire extinguishers have to be labeled?
Each fire extinguisher must be labeled or marked by the manufacturer with its UL rating. The fire extinguisher must be designed, constructed, and maintained to permit visual determination of whether it is fully charged.
People Also Searches a fire extinguisher must conform to which requirement
FIRE EXTINGUISHER REGULATIONS Video Answer
Reference:
https://www.usfa.fema.gov/
https://en.wikipedia.org/wiki/Fire_extinguisher